Caméra réversible film 9,5 mm
N° Inventaire : CNC-AP-20-1388
Collection : Centre national du cinéma et de l'image animée
Catégorie d'appareil : Prise de vues et projection cinématographiques
Nom du modèle : Campro Cine Camera Projector Standard Model
Numéro de fabrication : n° 5207
Lieu de fabrication : Londres, Grande-Bretagne
Année de fabrication : 1936
Copyright photo : Dabrowski Stéphane
Fiche détaillée
Type de l'appareil
entraînement du film 9,5 mm par deux griffes ; emplacement intérieur pour cassette métallique débitirice et réceptrice contenant 10 mètres de pellicule ; moteur à ressort ; viseur clair et pointeur ; compteur de pieds ; manivelle de remontage ; objectif avec trois diaphragmes interchangeables ; ampoule électrique "Lumax Campro" intérieur pour projection ; poignée en cuir
Auteurs
Informations non disponibles
Fabricants
Campro Ltd.
Londres, 23 City Rd., E.C. 1
Utilisateurs
Informations non disponibles
Distributeurs
Home Cine Cameras LTD
Londres, 18 Gray's Inn Road
Sujet du modèle
Informations non disponibles
Objectif
Campro Anastigmat
Taille de l'objet
Ouvert :
Informations non disponibles
Fermé :
Longueur : 17 cm
Largeur : 6 cm
Hauteur : 15 cm
Diamètre :
Informations non disponibles
Taille de la boîte de transport
Informations non disponibles
Remarques
Marques : "Campro Cine Camera Projector World's Patents Pending, Home Cine Cameras Ltd London" ; "Reduce stops as circumstances permit. Project F/1.9, Close ups dull F/3.5, Close ups light F/5.6, Medium scenes F/8, Open beach scenes F/16. Cine Camera-Projector Worlds Patents pending".
Caméra pouvant servir aussi de projecteur. Voir modèle avec variantes sur facade avant : AP-99-2163.
"All H.C.C. Cine Cameras take standard 30 ft. films of 9,5 mm width. Panchromatic films may be used when conditions demand an extra speedy film, or when it is desired to obtain correct colour contrasts, in which case filters should be used. Your dealer will supply the film in a standard charger. Do not attempt to open this, but notice that down one side is a loop of film. Pull out only sufficient of this loop from the top of the charger to pass over the rollers. [...] Using the Campro as a projector. Before projecting your films attention should be given to the following points : 1. See that the film is loose in its spool. New films should be unwound and rewound by hand before projecting, as as often they are too tightly wound. 2. See that the electrical contacts are clean and sound. 3. The camera must not be connected direct to the mains, but used either with a battery, accumulator, or transformer. If a battery or accumulator is used, see that it is reading 6 volts with the lamp burning. If a transformer is used, see that you have followed the instructions as to correct input voltage sent out with this instrument. 4. A two pin connector plug is provided to connect with the electric supply. Two sockets will be found at the back of the camera to accomodate the pins on this plug. 5. Stand the camera 6 to 8 ft. from the screen and connect the terminals to the electric supply. If the screen is not evenly illuminated ease the screw on the lamp holder and adjust the lamp backwards or forwards until the best position is found when the screen is evenly illuminated. At this position relock the screw on the lamp holder. 6. Set the aperture at F. 1.9. 7. Place the empty take-up spool on the take-up drive" (How to use the "Campro" combined Cine Camera Projector for 9,5 mm safety film, London, Home Cine Cameras Ltd., s.d.).
Bibliographie
Peter Ariel, Ariel Cinematographica Register, Allemagne, 1981-1989, ACR 450.
Home Movies & Home Talkies, August 1936, p. 122.
How to use the "Campro" combined Cine Camera Projector for 9,5 mm safety film, London, Home Cine Cameras Ltd., s.d.
